| The Process |
Owners decide what the project
will be in general |
Owners make a rough drawing,
with dimensions |
and meets with AGS employees
to work on details and stone selection |
Owners will select sink or
other fixtures, as needed, before the template is
prepared |
AGS makes a wooden template of
the project. |
Countertops may remain off
until stone is installed |
AGS takes the plumbing
fixtures with the template back to the shop |
Template is secured to stone
where rough cuts are made to section major parts. |
A large section is rough cut
and put aside |
The seam must be precise and it will take some time,
effort, and expertise |
Finishing the seam edge |
Edging machine is configured |
Edging is done per design
plan. Many edges are available at AGS. |
The template for the sink is
set up and material removal begins |
The sink hole is
ready. |
The truck and technicians
arrive |
The components go into the
home |
The sink has to go in before
the countertop if it is to be mounted beneath the
countertop |
The first countertop goes on
the cabinet |
Fine tuning is being done in
the driveway |
The second countertop is
installed |
This is definitely a two man
job |
The seam is tightened so it is
nearly transparent |
The sink is
connected |
Final product: pass-through from dining
room side |
Final product: kitchen view from sink
area |
Final product: Sink and largest countertop.
Simple kitchen "souped up" |
Final product: small countertop |
